Thin-film coatings applied to existing windows, walls and roofs. For buildings that need measurable improvement in performance without dismantling, renovation or downtime.
Adalio designs and manufactures thin-film thermal insulation coatings for the windows, walls and roofs of existing buildings - no glass replacement, no facade demolition, no operational downtime. Three products, one physics:
The surface where the building loses energy points to the product. Three paths, three datasheets.
In summer the glazing heats the interior with infrared. In winter glass loses heat 4-6x faster than a wall of the same area.
A roof in full sun reaches 70-86°C. Thermal bridges and thin insulation cool walls in winter.
Steam pipelines, heat nodes and valves lose heat and pose a burn risk during operation.
Thermal conductivity of the IzolPlus coating. The lower it is, the slower heat penetrates the partition. Measured and published in the peer-reviewed journal MDPI Energies (2022).
MDPI Energies 2022
Active TT film (South variant) reflects over 94% of infrared radiation - the main carrier of solar heat. In summer the glazing does not overheat the interior, and the window stays bright (VLT 70%).
Datasheet Wer. 6
Coating the roof with IzolPlus Bitum lowered its surface temperature by over 42°C in full sun (bitumen felt 71-86°C, after coating 17-21°C). Thermographic measurement, AAM Driveline, Świdnica 2023.
AAM Driveline 2023
Fire classification of the coating: non-flame-spreading (NRO), euroclass reaction to fire C-s1-d0 per the PN-EN 13501-1:2019-02 standard.
PN-EN 13501-1:2019-02
We do not rebuild the building. We improve its working surface.
Thermoreflective coatings with microspheres. Six products: Bitum, Termo-Fasada, Termo-Wnętrze, Grunt, Tynk, TERMO STOP. Applied by spray or roller on existing surfaces - no dismantling.
82-micron multilayer PET film with triple-layer Active TT nanocoating. Applied to existing double-glazed units - no window removal.
/ Projects · trusted by
-40°C vs uncoated roofUncoated bitumen roof 71-86°C, locally up to 102°C in drainage channels. After two-coat Bitum 17-21°C in full sun. Differential over 40°C.
Each in a different scenario, each with their own before-and-after measurement.
Thermal audit of the building: thermography, envelope assessment, variant selection and an ROI scenario. No cost for the end client.
Request a B2B audit →Datasheets, PZH and CE approvals, NRO fire classification and two peer-reviewed publications with DOI. A full document set for specification.
See certificates →Partner network under reconstruction: territorial exclusivity, training, leads and margin on Active TT films and IzolPlus paints.
Become a partner →B2B audit: thermography, envelope assessment, variant selection, ROI scenario. We work with facility managers, engineers and architects.
Indicative values. The audit will provide concrete numbers for your building.